This Multi Angle Hanger has a 5-inch swing arm with a pivoting 2-inch long end. Once the angle is set on the 2 inch limb, the instrument can be fitted closer to the wall by adjusting the wall plate angle. Also available with an 8-inch swing arm.
The padded cradle pivots to securely hold the instrument's headstock. Spacing is dependent on the pivoting angle chosen as well as the thickness of the instrument resting in the hanger
- Mounting hardware including (flat wall installation)
- Slatwall clip included (slatwall installation)
- This clip prevents the hanger from lifting off of your slatwall when the instrument is removed
Made in the USA and backed by a lifetime structural warranty.
Installation Instructions:
Flat Wall: Choose location for hanger. Drive screws through mounting holes of hanger into wall using a phillips screwdriver. If a wall stud is not found, these pilot holes are necessary for installing the plastic toggles. To do this, use the screwdriver to push and turn the toggle clockwise until flush. Remount hanger with screw into toggles. DO NOT REUSE TOGGLES.
Slatwall: Hook the clip into your slatwall system, just to the left of the hanger. Then, gently pull the lip open on the right edge of the clip, and slide it over the hanger plate. Make sure that the lip has locked in place securely around the right edge of the plate. (This clip allows for movement of the plate, without allowing it to lift off your slatwall when the instrument is removed.)
